Knowledgebase: Central Plant > Other
Plant Load Profile
Posted by Richard Raustad, Last modified by Michael J. Witte on 28 November 2017 07:16 PM
Q: I'm trying to do a simulation using the PLANT LOAD PROFILE object; no zones are simulated.
Run: 1 design day.
Building: None.
System: None.
Plant: PLANT LOAD PROFILE with Boiler and bypass.

I would like to have the setpoint temperature on supply outlet node by varying the temperature of the boiler, is it possible to do it?

A: The Plant Load Profile object is used to "pass" a load to the plant where the plant meets this load. The load profile places an inlet and outlet water temperature and a mass flow rate at the inlet to the plant loop. This is where you will need to focus when you try to alter the boiler performance.
(181 vote(s))
Not helpful