Knowledgebase: Central Plant > Other
Plant Load Profile
Posted by Richard Raustad on 28 January 2010 02:02 PM
Q: I'm trying to do a simulation using the PLANT LOAD PROFILE object; no zones are simulated.
Run: 1 design day.
Building: None.
System: None.
Plant: PLANT LOAD PROFILE with Boiler and bypass.

I would like to have the setpoint temperature on supply outlet node by varying the temperature of the boiler, is it possible to do it?


A: The Plant Load Profile object is used to "pass" a load to the plant where the plant meets this load. The load profile places an inlet and outlet water temperature and a mass flow rate at the inlet to the plant loop. This is where you will need to focus when you try to alter the boiler performance.
(181 vote(s))
Helpful
Not helpful

Comments (0)
Post a new comment
 
 
Full Name:
Email:
Comments:
CAPTCHA Verification 
 
Please enter the text you see in the image into the textbox below (we use this to prevent automated submissions).